Any thoughts as to the benifits of Romer over Faro? My shop is thinking of getting a portable CMM and I'd like to get some imput as to which you think is better. Also do you have any suggestions in gereral for what to be careful about with portable CMMs?
we recently bought a faro gage arm. as far as using it if it used in the way it was designed for it works great. if you are normally used to running PcDmis i would advise against the Faro software it is too limiting and the tech support we get fro Hexagon is 10 times better than at Faro. Just one programmers observation. i would also advise doing a correlation study between the arm and your normal cmm and see the difference it would have on using it in the manufacturing area. hope this helps Scott Bean
we recently bought a faro gage arm. as far as using it if it used in the way it was designed for it works great. if you are normally used to running PcDmis i would advise against the Faro software it is too limiting and the tech support we get fro Hexagon is 10 times better than at Faro. Just one programmers observation. i would also advise doing a correlation study between the arm and your normal cmm and see the difference it would have on using it in the manufacturing area. hope this helps Scott Bean
