Any thoughts as to the benifits of Romer over Faro? My shop is thinking of getting a portable CMM and I'd like to get some imput as to which you think is better. Also do you have any suggestions in gereral for what to be careful about with portable CMMs?
We are using a FARO arm with Geomagic software (Studio & Qualify). We did a correlation of a scan to the same part run on the CMM - very close, <0.02mm.
This may not be close enough for your parts, but since we make and measure raw sand castings, this is fine for us.
We are using a FARO arm with Geomagic software (Studio & Qualify). We did a correlation of a scan to the same part run on the CMM - very close, <0.02mm.
This may not be close enough for your parts, but since we make and measure raw sand castings, this is fine for us.