That sounds too simple...
running 3.5 here, and im oder to copy & paste from one prg to another i have to
1.) Place "RECALL/STARTUP" at the very end of the "copy"-program.
2.)Copy features, and paste them below the RECALL/STARTUP in the same "copy"-program.
3.) Cut and paste these points ( I usually "F3" prior to be able to id them in the new prg.) Paste them in the "PASTE"-prg at the BEGINNING after STARTUP.
4.) Now cut and paste them where you need them
BEWARE, you need to re-identify your ALIGNMENT/RECALL
and be sure not to have copied any features or alignments with the same id.
That sounds too simple...
running 3.5 here, and im oder to copy & paste from one prg to another i have to
1.) Place "RECALL/STARTUP" at the very end of the "copy"-program.
2.)Copy features, and paste them below the RECALL/STARTUP in the same "copy"-program.
3.) Cut and paste these points ( I usually "F3" prior to be able to id them in the new prg.) Paste them in the "PASTE"-prg at the BEGINNING after STARTUP.
4.) Now cut and paste them where you need them
BEWARE, you need to re-identify your ALIGNMENT/RECALL
and be sure not to have copied any features or alignments with the same id.