Does anyone know why when using a Romer PCMM, the measurements for outer diameters measure small, while the inner diameters measure large?
I was told from Romer tech support that it is the deflection of the probe. I find it hard to believe that the probe is deflecting .010 when using the 6mm probe and a soft touch.
I'm getting the same results with both or our Romer arms, and with either the 3mm or 6mm probes. I also get the same results when using our PowerInspect software. Both arms have been calibrated recently.
Any thoughts or is anyone else experiencing the same issue?
Tips are calibrated regularly. In fact this occurs even after the arm is calibrated at Romer. They calibrate the tips and the arm all at the same time and send a new "Arm Data" file with the arm.
There is no "trigger" using these hard probes. The probe contacts the part and the operator presses a button to accept the hit.
Tips are calibrated regularly. In fact this occurs even after the arm is calibrated at Romer. They calibrate the tips and the arm all at the same time and send a new "Arm Data" file with the arm.
There is no "trigger" using these hard probes. The probe contacts the part and the operator presses a button to accept the hit.