I inserted a Dcc program into a Romer data base, then added a probe change for the HP-L-20.8 Scanner and edited out he codes that were not needed "move points, tip changes etc... Then went to edit the perimeters in the existing code (f9) and the software pops up an error stating that the surface point is not supported by the current laser. It will allow me to create a new surface point just not edit the older code????
I took the class a few week back and we were able to do it.... One thing I did notice is that the scanned would not do Vector points so, I had to change them over to Surface points. After I walked away from the issue for a few days I noticed the program was about 10000x the size ... I made the changes offline and hopefully I will get it to work the next time I am at that shop....
I took the class a few week back and we were able to do it.... One thing I did notice is that the scanned would not do Vector points so, I had to change them over to Surface points. After I walked away from the issue for a few days I noticed the program was about 10000x the size ... I made the changes offline and hopefully I will get it to work the next time I am at that shop....
... I made the changes offline and hopefully I will get it to work the next time I am at that shop....
