I inserted a Dcc program into a Romer data base, then added a probe change for the HP-L-20.8 Scanner and edited out he codes that were not needed "move points, tip changes etc... Then went to edit the perimeters in the existing code (f9) and the software pops up an error stating that the surface point is not supported by the current laser. It will allow me to create a new surface point just not edit the older code????
Autofeatures are linked with the technology used in your Probe command loaded while building the feature. There is currently no possibility to modify an Autofeature created with a tactile probe to fit as an Extraction laser Autofeatures. There are other parameters involved using this functionality. They only thing you could do is exporting the features. Loading your correct laserprobe , import the xyz file and create Autofeatures from these imported features. We will try to improve this behavior for the next versions, so you are able to switch different probe technologies without having to rebuild the Auto features.
Autofeatures are linked with the technology used in your Probe command loaded while building the feature. There is currently no possibility to modify an Autofeature created with a tactile probe to fit as an Extraction laser Autofeatures. There are other parameters involved using this functionality. They only thing you could do is exporting the features. Loading your correct laserprobe , import the xyz file and create Autofeatures from these imported features. We will try to improve this behavior for the next versions, so you are able to switch different probe technologies without having to rebuild the Auto features.
