I tried to create the FCF shown on the print using the Xactmeasure true position, but I had a error message pop up. So I'm just looking for someone to confirm that the print has Bad GDnT.
Just asking, If it was a composite callout, the print would be 100% wrong. Cannot have different datum in 2nd callout. Now, the question is, since it is a 2 segmented callout, is the print legal? I run into this all the time with our prints. I am hoping there is some GD&T guru out there that can answer this. Xact measure will not allow it whether its composite or 2-segmented.
Just asking, If it was a composite callout, the print would be 100% wrong. Cannot have different datum in 2nd callout. Now, the question is, since it is a 2 segmented callout, is the print legal? I run into this all the time with our prints. I am hoping there is some GD&T guru out there that can answer this. Xact measure will not allow it whether its composite or 2-segmented.
