I tried to create the FCF shown on the print using the Xactmeasure true position, but I had a error message pop up. So I'm just looking for someone to confirm that the print has Bad GDnT.
The op does not show a composite frame. It is multiple single-segments.
Perhaps a better explanation would be found in
7.5.5 Multiple Positionsl Tolerances for a Pattern of Feature of Size.
If different datums, different datum modifiers, or the same datums in a different order of precedence are specified, this constitutes a different datum reference frame and design requirements. This is not to be specified using the composite positional tolerancing method. A separately specified tolerance, using a second sinlge-segment feature control frame is used, including applicable datums, as an independent requirement. See Fig. 7-55
I know the op does not have a pattern, but I think this is how it should be done.
The op does not show a composite frame. It is multiple single-segments.
Perhaps a better explanation would be found in
7.5.5 Multiple Positionsl Tolerances for a Pattern of Feature of Size.
If different datums, different datum modifiers, or the same datums in a different order of precedence are specified, this constitutes a different datum reference frame and design requirements. This is not to be specified using the composite positional tolerancing method. A separately specified tolerance, using a second sinlge-segment feature control frame is used, including applicable datums, as an independent requirement. See Fig. 7-55
I know the op does not have a pattern, but I think this is how it should be done.
