I am dimensioning true position of a few holes, the diameters are out of tolerance (to big) so should they still benefit from the MMC and gain that Bonus tolerance?
or do they not receive bonus since the diameter is out of tolerance?
I've seen a few situations where the diameters are to big but still receive the full bonus, and situation where the diameter is to big and not receive any bonus.
It has always been my understanding that if the hole size fails or the stud size fails, then NO bonus is allowed. As far as I know, Pcdmis has also always done it this way. Failures can not in any way aid your process.
It has always been my understanding that if the hole size fails or the stud size fails, then NO bonus is allowed. As far as I know, Pcdmis has also always done it this way. Failures can not in any way aid your process.