I am dimensioning true position of a few holes, the diameters are out of tolerance (to big) so should they still benefit from the MMC and gain that Bonus tolerance?
or do they not receive bonus since the diameter is out of tolerance?
I've seen a few situations where the diameters are to big but still receive the full bonus, and situation where the diameter is to big and not receive any bonus.
The bonus is still applied to position even when the diameter is oversized. It doesn't give you more bonus than the spec allows, it will only give you the max but either way the size is out so Rule #1 applies.
The bonus is still applied to position even when the diameter is oversized. It doesn't give you more bonus than the spec allows, it will only give you the max but either way the size is out so Rule #1 applies.