NPI Measurement Hardware Adive

Ben1989 over 6 years ago

Hi all,

Hope you had a great Christmas and New Year!

I'm writing as I'm seeking metrology advice for products that will quickly go through our aerospace shop.

The products are simple, flat, relatively thin composite components. It will be an in-process measurement where only two dimensions need measuring; profile and hole true position.

If you refer to the very rough drawing I've attached. The component's thickness can simply be measured with a vernier.

At the moment I'm thinking of a Romer Arm but I'm wondering if there's anything out there where you can simply throw the component onto a surface and automatically be measured.

Hope I've described what I'm working with well and is understood

Cheers, Ben

Parents

Ben1989 over 6 years ago

Throw the component onto a surface and automatically be measured? lolol I love it when non cmm people say cr@p like that.

For what you're doing I'd suggest a programmable vision system like an OGP. If you really want to stay with PC DMIS then look into the Optiv

Funnily enough I am CMM based haha. But they're the orders from management. I was looking into OGP as an option but does it offer anything over a Laser Romer Arm?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Ben1989 over 6 years ago

Throw the component onto a surface and automatically be measured? lolol I love it when non cmm people say cr@p like that.

For what you're doing I'd suggest a programmable vision system like an OGP. If you really want to stay with PC DMIS then look into the Optiv

Funnily enough I am CMM based haha. But they're the orders from management. I was looking into OGP as an option but does it offer anything over a Laser Romer Arm?
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data