hexagon logo
Register Sign in
  • Replies 24 replies
  • Subscribers 33 subscribers
  • Views 378 views
  • Users 0 members are here
Options
Related

PC-DMIS won't create an auto-circle

jasonsfunderburk
I have created a plane (1) and am attempting to create an auto-circle for a hole on that plane which is .098" in diameter. My probe is 3mm. So while yes, I understand the error message (Sizes for a contact feature should be greater than probe diameter.) I should be able to create a 1 point circle on that plane and have done this successfully in the past many many times. Any ideas what might be going on here?

And sorry, running 2017 R2 sp6... that recently updated... wonder if thats what is causing this to not work all the sudden.
Parents
  • I have had the same problem doing a one point circle. It used to work just Like tio OP said, I program my romer offline so I run into this a lot.
    The simple solution I found was to turn on quick measure, pick single point circle, select your plane feature from the pulldown and then pick your circle. Using autocircle used to work and now fails, but this method give the same result. A one point auto circle.
Reply
  • I have had the same problem doing a one point circle. It used to work just Like tio OP said, I program my romer offline so I run into this a lot.
    The simple solution I found was to turn on quick measure, pick single point circle, select your plane feature from the pulldown and then pick your circle. Using autocircle used to work and now fails, but this method give the same result. A one point auto circle.
Children
© 2024 Hexagon AB and/or its subsidiaries. Privacy Policy | Cloud Services Agreement