The above callout isn't seeming to work well in pc-dmis and not sure if you gents would even consider this a legal callout. As you can see the FCF references three holes. Two of the holes are .218 - .229" and the third is actually a helicoil thread that has a minor diameter of .201". When I input this into pc-dmis it doesn't really work. Any ideas?
inspector... just use something other than pc-dmis... not even sure... but they liked me enough to give me a 5 dollar an hour raise over where im at now.
inspector... just use something other than pc-dmis... not even sure... but they liked me enough to give me a 5 dollar an hour raise over where im at now.