The above callout isn't seeming to work well in pc-dmis and not sure if you gents would even consider this a legal callout. As you can see the FCF references three holes. Two of the holes are .218 - .229" and the third is actually a helicoil thread that has a minor diameter of .201". When I input this into pc-dmis it doesn't really work. Any ideas?
yeah, it appears that it will do the xactmeasure but i'm a little worried about when it reports the hole size as it lists the diameter as zero... the bad part is that I won't be here to run the program.
yeah, it appears that it will do the xactmeasure but i'm a little worried about when it reports the hole size as it lists the diameter as zero... the bad part is that I won't be here to run the program.