Can a hole axis be create and recognized as T value in CAD. The part has a hole that is smaller than any probe tip I have available. I would like to be able to place probe at surface of the hole and wall and recognize the hole axis real time in T (CAD). I have 2016 CAD++ SP7. Thanks in advance.
OK Thanks for the replies. I had verisurf before and was able to create hole axis in CAD and was able to get real time data in build inspect mode quickly using the hole axis. It doesn't look like I will be able to do this with PC DMIS. Using PC DMIS it looks like I will have to go the extra step and measure and dimension the hole to get the info needed. Thanks again for the help.
I went through the same troubles when switching from Verisurf to PC-DMIS. Try creating an auto-circle with a single point, execute it, and pull up your DRO with Dx,Dy and nest the probe.
OK Thanks for the replies. I had verisurf before and was able to create hole axis in CAD and was able to get real time data in build inspect mode quickly using the hole axis. It doesn't look like I will be able to do this with PC DMIS. Using PC DMIS it looks like I will have to go the extra step and measure and dimension the hole to get the info needed. Thanks again for the help.
I went through the same troubles when switching from Verisurf to PC-DMIS. Try creating an auto-circle with a single point, execute it, and pull up your DRO with Dx,Dy and nest the probe.
