We use our arm for measuring parts after test. Right now trying to see if we can compare a scan of a sample taken before test to a scan of the same sample taken after test. Our romer arm and sample fixture don't move so I don't think I need to worry about doing any sort of alignment... yet. Does anybody know if there is a way to do a colormap between two scans instead of between a CAD and a scan?
I tried exporting one of the scans to an IGES and then importing the same IGES to try the scan but nothing showed up.
actually, it is not quite the same as the EQUATE alignment that you do on the CMM, it basically does the same thing, and it is actually called LEAPFROG.
Yeah, it's a 'start-over now that you know' kind of thing. The learning curve as it were.
actually, it is not quite the same as the EQUATE alignment that you do on the CMM, it basically does the same thing, and it is actually called LEAPFROG.
Yeah, it's a 'start-over now that you know' kind of thing. The learning curve as it were.