So I came across a Part without a CAD model, made a pointcloud, exported it out as IGES. and when I try to import it into Solidworks or even back into PC-DMIS, it is grossly slow, and sometimes when the pointcloud is huge it won't even load. Wondering if there is a trick or if you can down size it, or maybe there is a trick to exporting the pointcloud so one could create an actual good model in Solidworks or other product, that might be friendly. I have created Mesh and exported them out as STL, but these are sloppy and not as friendly, but they do load a lot easier. Any tid bits anyone have to offer?
neil.challinor perhaps?
Ok, XYZ is the better choice, got it working,
vpt.se your suggestion helped but it was still extremely slow. Thanks again for that little tid bit. I will still mess with it a little more to see if I can't get that to work better.
neil.challinor and
Matthew D. Hoedeman thank you for the suggestions. much appreciated.
Ok, XYZ is the better choice, got it working,
vpt.se your suggestion helped but it was still extremely slow. Thanks again for that little tid bit. I will still mess with it a little more to see if I can't get that to work better.
neil.challinor and
Matthew D. Hoedeman thank you for the suggestions. much appreciated.