Good morning
I am a brand new user with the romer arm. Could any one direct me on where to obtain the information I need to get started with a base alignment? Please and thank you.
That's a terrific place to start. I couldn't post a snippet for proprietary reasons. Is there a a good resource out there to explain this process step by step?? I am literally a new user to this software. I am not without knowledge as a whole. I understand cartesian geometry, gd&t and have used other similar software controls. But i am not sure about the process/idea of the second step in your reply "correct the theoreticals". Would you know a good resource where i can learn that idea??
That's a terrific place to start. I couldn't post a snippet for proprietary reasons. Is there a a good resource out there to explain this process step by step?? I am literally a new user to this software. I am not without knowledge as a whole. I understand cartesian geometry, gd&t and have used other similar software controls. But i am not sure about the process/idea of the second step in your reply "correct the theoreticals". Would you know a good resource where i can learn that idea??
Well, when you create the features, they will have theoretical values and measured values. At the point of creation, these will be the same (both THEO and MEAS). You will need to correct/edit the THEO's so they match the print - or what they should be.
