Iterative Alignment
Level -- 3 surface points to "Z"
Rotate -- Hole /Slot
Origin -- Hole
The issue I have is that all features are out in "z" 3mm. (the 3 leveling point check good, 0.00mm)
I added a 4th surface point to the "z" plane and did a second iterative alignment using two holes and a slot for my leveling points. Now all features check good, including the 4th surface point but the original three surface points check 3mm out.
I have re- certified my probe tip and rerun with the same issue. I find no offsets and my tip comp is on. PC-DMIS CAD++2017R2. Any idea what could cause this issue?
