PC-DMIS programs on a Faro arm

V 3.7 MR3/4

What are the pitfalls of using existing programs written for a DCC CMM with a FARO arm.

Is there a lot of conversion needed?

Must the program be re-written to function in a manual mode?

Can you just remove the DCC mode command from the code and go?

Stuart over 16 years ago

Removing the DCC command isn't even necessary. The only thing to change in the program is adjusting the Probe change commands. All you need are the probe commands that reference the Faro.

Stu
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
Kaiyureboy over 16 years ago

Yep, thanks, thats good idea.

I tried some possibilities ( etc.) but with no success.
____________________________________________________________________________________
Angelina Jolie Johnny Depp Al Pacino Brad Pitt site Robert De Niro
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel