This is getting ridiculous, sometimes when running alignments on planes, PC-DMIS flips the part 180°, despite the
fact that all my vectors are correct, theos and whatnots. We have to remeasure the part several times and hope
to hit the correct millisecond PC-DMIS uses to create the alignment correctly...
This is unacceptable and needs to be fixed - is it just me that suffers from this? We are burning daylight because
of the software at this point and not because the parts are incorrect - because we never get to the point where
we can see that...
Neil Challinor It doesn't even work with bestfit alignments as the primary plane used for alignment gets flipped.
If this is a "thing" in PC-DMIS that can't be fixed, please tell me that so I can find another software that works...
Is there anything in the settings editor or the general settings that can cause this behaviour?
EDIT: Pardon my tone, but we have higher-ups whipping our behinds.
PLAN_A =ELEMENT/PLAN,REKTANGULÄRA,KONTUR,NEJ,GAUSS
TEOR/<0,-312.819,-170.147>,<-1,0,0>
MÄTT/<786.374,-681.37,-725.283>,<-0.0237684,0.999715,-0.0022286>
KONSTR/PLAN,BA,PKT_A1,PKT_A2,PKT_A3,,
TA_BORT_EXTREMVÄRDEN/AV,3
FILTER/AV,VÅGLÄNGD=0
REFDEF/A,ELEMENT=PLAN_A,,
A1 =UPPRIKTNING/START,ÅTERKALLA:START,LISTA=JA
UPPRIKTNING/PRIMÄR,XMINUS,PLAN_A
UPPRIKTNING/FLYTTA,X-AXEL,PLAN_A
UPPRIKTNING/SLUT
This is the measurement and alignment that flips.
