Remeasure feature in a loop

Is there any way to remesure a single looped feature? I have a program that loops through 216X radial bore pattern with an absolute arm. Its easy to accidently measure the wrong hole once in a while. Is there a way to go into the loop and only remeasure say CIR1[3] and not rerun the entire loop? Thanks

Parents

0 kingsld1 3 months ago

You could do a check on the measured value after each feature to see if the deviation is a "reasonable value". If the deviation is greater than "reasonable value" then make a loud noise, display the results and ask if you want to remeasure the feature. If YES then jump back to a label before the feature measurement and try again.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Reply

0 kingsld1 3 months ago

You could do a check on the measured value after each feature to see if the deviation is a "reasonable value". If the deviation is greater than "reasonable value" then make a loud noise, display the results and ask if you want to remeasure the feature. If YES then jump back to a label before the feature measurement and try again.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Verify Answer

Cancel

Children

No Data