Measuring Chamfers

I am using powerInspect for my infinite romer arm.

I am having a hard time figuring out the best way to measure a chamfer.

My exampler today was measuring the chamfer on a hole for a bolt on a wheel/tire assembly.

I was ablt to get some sort of .20 x 60 degrees measurements using calipers and a protractor, but i am hoping there is a way using PowerInspect.

I am new to this field and any help would be greatly appriciated.

Brian

Parents

jamesmrbond007 over 16 years ago

i tried setting up a cone i tried it with 2 different probes. i measured it by hand at about 60 degrees and power inspect told me it was around 42...am i just not thinking about the angle correctly or is the range of accurancy much much higher as previously stated.

brian
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

jamesmrbond007 over 16 years ago

i tried setting up a cone i tried it with 2 different probes. i measured it by hand at about 60 degrees and power inspect told me it was around 42...am i just not thinking about the angle correctly or is the range of accurancy much much higher as previously stated.

brian
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data