I am measureing a lot of manual points due to the type and repeatabilty of my part, when I am programing these points the crosshair is nice and big, however, when I execute the program the crosshair reverts back to the very small one. Is there a way to get the large one back during program execution?
Can you clarify - are these Edge Point features measured as "Manual Targets"?
At execution time, you should see two round handles on the cross hair target. The green one is the handle to rotate the cross hair. The other handle (in the colour of your cross hair) allows the cross hair to be made bigger.
Another thing that might help - you can also change the colour of the cross hair (in the probe toolbox - Define Targets page) to make it stand out better on the surface.
Can you clarify - are these Edge Point features measured as "Manual Targets"?
At execution time, you should see two round handles on the cross hair target. The green one is the handle to rotate the cross hair. The other handle (in the colour of your cross hair) allows the cross hair to be made bigger.
Another thing that might help - you can also change the colour of the cross hair (in the probe toolbox - Define Targets page) to make it stand out better on the surface.