I am measureing a lot of manual points due to the type and repeatabilty of my part, when I am programing these points the crosshair is nice and big, however, when I execute the program the crosshair reverts back to the very small one. Is there a way to get the large one back during program execution?
What I am tring to do is position the probe to measure a read point at the cursor position, but during execution the crosshair is small and hard to locate, when I am programing initially the crosshair is adjustable and thats how I want it when I run the parts. Is that possible. Also, is it possible to input into the program the use of the protractor gage or any of the other gages?
What I am tring to do is position the probe to measure a read point at the cursor position, but during execution the crosshair is small and hard to locate, when I am programing initially the crosshair is adjustable and thats how I want it when I run the parts. Is that possible. Also, is it possible to input into the program the use of the protractor gage or any of the other gages?
