Does anyone have an instructional document on how to change lenses? I have a Tesio300 that came with a 2X lens installed and a 0.5X lens as an extra and I want to use the 0.5X lens but can't. I thought I had it in correctly by removing the ring light and screwing it in underneath but when I tried to calibrate it to the ROI solid block master I could not get the .562 square to fit in the graphics display window. Any help would be appreciated.
There is no extra lens for X1, so you can screw the lens without any cover removing, just with your little fingers. But I am surprise because using a ROI slide with a dongle for TESA VISIO is not allowd...
It's an option in the calibration routine and it's the only artifact I have to cal. to. Back to the install, I just screw the0.5x lens onto the bottom of whats there and create the new probe file and thats it...i'll give it a try.
There is no extra lens for X1, so you can screw the lens without any cover removing, just with your little fingers. But I am surprise because using a ROI slide with a dongle for TESA VISIO is not allowd...
It's an option in the calibration routine and it's the only artifact I have to cal. to. Back to the install, I just screw the0.5x lens onto the bottom of whats there and create the new probe file and thats it...i'll give it a try.
