I am trying to cal a Mycrona using PcDmis Vision and it keeps wanting me to line up with a retangular target. I have centered on i think every target possible. I would really appreciate any help with this. Thanks all.
Mycrona Signum RL
PcDmis Vision 4.3mr1
Hexagon Calibration scale
I am running 2010 MR3 without to much trouble, tried 2011 but had some calibration issues so far. sounds like the head is bumped. mine did the same thing after i bumped it. it doesn't take much. but anyhow, mine would not calibrate either with this issue. when changing direction up or down the crosshair shifts off of what you are focused on. once the head was back square the cal went fine.
I am running 2010 MR3 without to much trouble, tried 2011 but had some calibration issues so far. sounds like the head is bumped. mine did the same thing after i bumped it. it doesn't take much. but anyhow, mine would not calibrate either with this issue. when changing direction up or down the crosshair shifts off of what you are focused on. once the head was back square the cal went fine.
