It was an old bug (2010 or 2011), when you want to calibrate the ring position (with a TTP), it works if you do it by the calibration window, but it doesn't work if you save a set parameter : the CMM goes to the 0 machine, instead of 0 ring... Be carefull of collision on this case !!!!!
I use it in a prog of CMMV calibration.
Were you able to calibrate the offset with 2013 SP1? I got this error message after 3 manual hits: BFCIRCLE_VISIONTOOLMOVED: feature do not intersect/math does not converge.
Were you able to calibrate the offset with 2013 SP1? I got this error message after 3 manual hits: BFCIRCLE_VISIONTOOLMOVED: feature do not intersect/math does not converge.