I have been running a program and turned on the laser pointer to help locate my part. Now when I run the program between each feature it automatically comes on again and you have to sit by the machine and manual shut it off each time. This is affecting the point location on the part.
Just a question (not completely familiar with that feature). You said you turned it on, so are you adding in the code to turn it off? Not sure if this is a option or if it is even ran by code but I thought that I would ask.
Just a question (not completely familiar with that feature). You said you turned it on, so are you adding in the code to turn it off? Not sure if this is a option or if it is even ran by code but I thought that I would ask.