CMM_Ve doesn't show anything...

Just installed 2013MR1SP1 (not 2 !), and when I want to use the cmm_ve after a ttp, the video screen stays black, write "no camera", and the only way to go though is "ctrl alt del"... Nice enhancement ! After re open PC-DMIS, all is ok.
Someone has the same problem, or is it just my config (global leitz protocol + tesastar r + cmm ve - windows 7 32b)
Have a good week-end all !

JEFMAN over 10 years ago

I tried with 2013 MR1 SP2 this morning, the problem is the same :
When i open PC-DMIS, I can measure with contact (LSPX1-M, tesastar-p or tp2) or without (CMM-Ve). If I change from CMM-Ve to LSPX, all is ok, if I change from LSPX to CMM-Ve, PC-DMIS says "no camera", and if I click on a vision function, a lot of items are greyed out and I can't quit without "killing" the processus in ctrl alt del...
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
JEFMAN over 10 years ago

Problem solved !
I know that some guys here will ask me how it has been solved... Well, I don't really know !!!!!!!
I changed the port com of the changer (I had a usb to com connector, I changed to a com card inside the PC), I re-installed the video card driver, I check all the connections between cmmv controller, IS1-2,PI200 and tesa aer, I cleaned the contact of the cmmv and the tesa star m, and I also changed port com of the cmmv controller. I wrote a new program, it works, and now the old prog works to...
Hope this help someone, one day...
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
JEFMAN over 10 years ago

from 2013 MR1 SP3 release note :
PCD-47839 - Fixed an issue where the "CAMERA:NONE" message appeared in the Live View window in a DC environment when PC-DMIS Vision was configured with a CMM-V probe and was changed to use a touch trigger probe (TTP) or scanning probe, and then was changed back to a CMM-V probe.
Thanks to those who fixed it !!!!!
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel