R&R Quick-Load Corner & Magnetism

Just seeing if anyone has had the probe error out using the Quick-Load Corner fixture?

The problem that I ran into is that the magnets that hold the vision plate in place, created a large enough magnetic field that wouldn't allow my probe hit to register. I moved my fixture away from the magnetic zone, and it worked great.

What I don't get is that the program I have in this area has been located there for over a year and I have never had any problems with it, until now.

Does anyone know what may cause this?

Running the Optiv 321GLtp.

Peter Fuller over 9 years ago

Just seeing if anyone has had the probe error out using the Quick-Load Corner fixture?

The problem that I ran into is that the magnets that hold the vision plate in place, created a large enough magnetic field that wouldn't allow my probe hit to register. I moved my fixture away from the magnetic zone, and it worked great.

What I don't get is that the program I have in this area has been located there for over a year and I have never had any problems with it, until now.

Does anyone know what may cause this?

Running the Optiv 321GLtp.

You mean why it changed or why it happened? Why it changed, I have no reasonable idea. Why it happens, it's built into the probe for probe changes. Magnets disable probes, you need a "Non Inhibit" probe if you need to work around magnets.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
bfire85 over 9 years ago

I understand the solution, but why all of a sudden now when we haven't had problems for over a year or two with the vision plate?

Sent from my VS985 4G using Tapatalk
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel