I had a question regarding illumination calibration files.
If I re calibrate my illumination to a different material I am using (
our company uses many) How can I make sure that those parameters are set specifically to that program so when I re calibrate that probe on a different material in a different program, do I need to save and command that cal file at the beginning of that routine.
It has been some time since my vision training, I know this can be done I just don't remember how.
I've just came back from vision training at Hex, In our case we are only inspecting one part and it was suggested to calibrate against that material instead of a piece of paper. Not sure if a parameter per material can be set up.
I've just came back from vision training at Hex, In our case we are only inspecting one part and it was suggested to calibrate against that material instead of a piece of paper. Not sure if a parameter per material can be set up.