Don't break the calibration chain!
I am posting this in hopes to have it made into a sticky since I see this issue arise a lot in the Vision section. This document perfectly explains the calibration process for calibrating offset with a Vision primary system with TTP.
I have a question on this. May I know what the last block of this code does? This is required for me to use in my calib routine. Thanks for your help in advance!!.
LOADPROBE/POINT3 OPTIV TIP/TIP1, SHANKIJK=0, 0, 1, ANGLE=0 AUTOCALIBRATE/PROBE, PARAMETER_SET=Sphere_Cal3, QUALTOOL_MOVED=NO, SHOW_SUMMARY=YES, OVERWRITE_RESULTSFILE=NO BEGIN AUTOCALIBRATE RESULTS FOR PROBE POINT3 OPTIV USING SET Sphere_Cal3 Probe file=POINT3 OPTIV Date=9/26/2016 Time=11:06:16 AM TIP1 THEO X -55.5000 Y 0.0000 Z 84.0000 D 0.3000 TIP1 MEAS X -55.5142 Y -0.0966 Z 84.2605 D 0.2879 StdDev 0.0008 END AUTOCALIBRATE RESULTS FOR PROBE POINT3 OPTIV USING SET Sphere_Cal3
What you asking? That is the probe calibration results to the sphere.
I have a question on this. May I know what the last block of this code does? This is required for me to use in my calib routine. Thanks for your help in advance!!.
LOADPROBE/POINT3 OPTIV TIP/TIP1, SHANKIJK=0, 0, 1, ANGLE=0 AUTOCALIBRATE/PROBE, PARAMETER_SET=Sphere_Cal3, QUALTOOL_MOVED=NO, SHOW_SUMMARY=YES, OVERWRITE_RESULTSFILE=NO BEGIN AUTOCALIBRATE RESULTS FOR PROBE POINT3 OPTIV USING SET Sphere_Cal3 Probe file=POINT3 OPTIV Date=9/26/2016 Time=11:06:16 AM TIP1 THEO X -55.5000 Y 0.0000 Z 84.0000 D 0.3000 TIP1 MEAS X -55.5142 Y -0.0966 Z 84.2605 D 0.2879 StdDev 0.0008 END AUTOCALIBRATE RESULTS FOR PROBE POINT3 OPTIV USING SET Sphere_Cal3
What you asking? That is the probe calibration results to the sphere.
