Vision/Tactile Mix for Alignments

Good Morning All,

Is it acceptable to use the touch probe for a manual alignment and then use the Vision probe for the Dcc alignment?

OR

Use both use touch probe and Vision for manual and touch and vision for Dcc alignment?

Thanks.

Parents

acgarcia over 7 years ago

Thanks for the info.

We've had our optiv for over a year in cell that only produced 1 part. I was never able to get the vision to work on it so it was inspected 100% with the touch probe. We've replaced the optiv with an Equator and I'm trying to do more with our optiv.

So in the area where they want to move the optiv to, most of the parts we want to inspect have more features that will use the touch probe(s) and maybe 1 or 2 features with vision.

I'm in the middle of ordering supplies to make fixtures for these parts.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

acgarcia over 7 years ago

Thanks for the info.

We've had our optiv for over a year in cell that only produced 1 part. I was never able to get the vision to work on it so it was inspected 100% with the touch probe. We've replaced the optiv with an Equator and I'm trying to do more with our optiv.

So in the area where they want to move the optiv to, most of the parts we want to inspect have more features that will use the touch probe(s) and maybe 1 or 2 features with vision.

I'm in the middle of ordering supplies to make fixtures for these parts.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data