Turn Light Off at the End of Routine

Good Afternoon Vision Users:

Is there a way to turn off the light on the machines at the end of a routine run? Machine runs 1 shift and will be in protected mode so is there a way to control this through a program? It might not matter but I would rather turn off the lights on the machine them leave them on if its possible.

JEFMAN over 7 years ago

There's a parameter in the setting editor, in the vision chapter. Try to search "auto shut off" , or "autoshutoff" (or shut" alone !) and change the value.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
bfire85 over 7 years ago

On the main screen, click Edit then Machine Interface Setup, under the Illumination tab, at the bottom, check "Turn Lamps Off at End of Execution"
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
acgarcia over 7 years ago

Awesome, thanks.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
bfire85 over 7 years ago

There is a setting that you can activate to turn off the lamp if switching to a touch probe. I don't recall the exact setting. It may be buried somewhere in the forums.
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
JEFMAN over 7 years ago

Choosing this parameter is nice during execution, but very boring during programmation !!!!!!!
You always have to set the light on for each new measurement...
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel
InspectorJester over 7 years ago
It'd be nice if there was a trigger you could add, like a clearplane

ILLUMINATION/OFF
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel