Is there a way when taking manual hits to increase the thickness of the cross-hair lines? We have some operators that have a difficult time lining up the cross hair with the proper edge because it is so thin.
Right click in the live view, isn't there a parameter ? (I'm not at the cmm, I only remember that you can change the size of points).
Another way could be increasing the distance to the edge (in pixels, at the bottom left of view config window)
Right click in the live view, isn't there a parameter ? (I'm not at the cmm, I only remember that you can change the size of points). Another way could be increasing the distance to the edge (in pixels, at the bottom left of view config window)
I can increase the pixel size of the point it creates, however the actual cross hair line thickness, I can't find anything in the settings to adjust that!
Maybe changing the color could help the operators ?
Tried that too. The part I'm working on is a stamped part, using ring light. There is a lot of light and dark, however there is a lot of noise around it. I need to reflect on certain transition zones. I can post a picture later.
I did put a suggestion in on the Suggestion Site if you want to vote for this to be added!!
