Changing from Port 2 tip to Port 3 tip causes port 3 tip to hang off or be picked up to left of center. Probe head still functions til it takes a hit. Then error message appears about bad hit etc. This happens about every 50th to 60th probe change. Keeps snapping.3mm (point 3 mm x 10 mm length) tips while running a 16 part fixture. Yes I can raise probe and reset tip ( green arrow button) and hit redo; but, this program is to run auto after being started by operator(s). I have cleaned tip. port etc yet is till occurs frequently! This is while using Optiv 443Dual Z with PC-MIS 2017R2
RandomJerk
InspectorJester ,
sealevel :
There's no "toolc.dat" on an Optiv ?
I thought that Probechanger.dat was only a "picturing" file for changers.
RandomJerk
InspectorJester ,
sealevel :
There's no "toolc.dat" on an Optiv ?
I thought that Probechanger.dat was only a "picturing" file for changers.
I also don't remember, as I am employed elsewhere now. However we did have a 6 port Renishaw probe changer that didn't have
too many issues; although sometimes seat 6 (which was closest to Y+) would have trouble seating our 45 degree probe, even after recalibration of the rack/probe.
