Changing from Port 2 tip to Port 3 tip causes port 3 tip to hang off or be picked up to left of center. Probe head still functions til it takes a hit. Then error message appears about bad hit etc. This happens about every 50th to 60th probe change. Keeps snapping.3mm (point 3 mm x 10 mm length) tips while running a 16 part fixture. Yes I can raise probe and reset tip ( green arrow button) and hit redo; but, this program is to run auto after being started by operator(s). I have cleaned tip. port etc yet is till occurs frequently! This is while using Optiv 443Dual Z with PC-MIS 2017R2
From what I've read in here, can you swap out the plates between stations to see if the bad behaviour changes with the plate? (the LSPX1C_0_SH) I know the rack calibration is a canned routine inside the Demon. As mentioned, I'll investigate tomorrow and report back.
** don't laugh @ probe name... it's late and I'm lazy!
From what I've read in here, can you swap out the plates between stations to see if the bad behaviour changes with the plate? (the LSPX1C_0_SH) I know the rack calibration is a canned routine inside the Demon. As mentioned, I'll investigate tomorrow and report back.
** don't laugh @ probe name... it's late and I'm lazy!
