Our Optiv classic likes to fail focus attempts even when the part is burr free and the plates a clean. Doesn't happen all the time but enough that its quite annoying. Is it possible to have the machine automatically retry a failed focus attempt.
Help File says that this something an "On Error" command can catch and deal with. No experience with Vision machines and limited use of the On Error command. From the Help file, the On Error on a Vision machine can tell if an Edge was not detected or Focus was not detected. From there you can code it to do nothing, Go To a Label, Set a Variable to One or skip the command. There is more information in the CMM core documentation.
Help File says that this something an "On Error" command can catch and deal with. No experience with Vision machines and limited use of the On Error command. From the Help file, the On Error on a Vision machine can tell if an Edge was not detected or Focus was not detected. From there you can code it to do nothing, Go To a Label, Set a Variable to One or skip the command. There is more information in the CMM core documentation.
