Our Optiv classic likes to fail focus attempts even when the part is burr free and the plates a clean. Doesn't happen all the time but enough that its quite annoying. Is it possible to have the machine automatically retry a failed focus attempt.
There are many Focus settings. Some setting might have been working, but barely...then it failed. Without knowing anything about your situation, I won't try to send you in any direction.
But... maybe try 'the part' and change the focus setting from Auto to Full.
good luck!
There are many Focus settings. Some setting might have been working, but barely...then it failed. Without knowing anything about your situation, I won't try to send you in any direction.
But... maybe try 'the part' and change the focus setting from Auto to Full.
good luck!
