Your Products have been synced, click here to refresh
the only problem I am having so far, is once I place the probe in the center of my diameter,(or as best placed as the eye can put it), I make that my read point. But when I go to place the actual alignment on the datum targets, they are not showing where they should.
any suggestions??
the only problem I am having so far, is once I place the probe in the center of my diameter,(or as best placed as the eye can put it), I make that my read point. But when I go to place the actual alignment on the datum targets, they are not showing where they should.
any suggestions??
© 2024 Hexagon AB and/or its subsidiaries. | Privacy Policy | Cloud Services Agreement |