Company bought a used CMM with PC Dmis software. Started using "Quick Start". Why dosen't Quick Start show results on the screen after your done measure a hole. Like CMM Manager after every measurment it shows XY locations and Dia. I'm new with PC Dmis is their something I have to setup to display the data after every measurment. Could use the help and advise. E-mail to
Wally@amcprecision.com
Well, maybe this will help. I have never used Quick Start. <disclaimer>
Start or open a program.
While in the Edit Window:
Press the F5 key. This will open up the "Setup Options" dialog box.
(you can then hit the F1 key for HELP on this dialog box. Look for Auto Dimension Setup)
Close the Help Window.
Look near the bottom of the dialog box for "Auto Dimension Setup".
Well, maybe this will help. I have never used Quick Start. <disclaimer>
Start or open a program.
While in the Edit Window:
Press the F5 key. This will open up the "Setup Options" dialog box.
(you can then hit the F1 key for HELP on this dialog box. Look for Auto Dimension Setup)
Close the Help Window.
Look near the bottom of the dialog box for "Auto Dimension Setup".
