Hey guys, I'm new to this whole forum thing. I just had a question that I'm not sure can be answered as I have inquired with many people about it. Has anyone had an issue with after starting up your computer and PC-DMIS the next day, whether you start running the part with your manual alignment marked or unmarked, that you have a vector change. By this I mean that instead of the probe moving to a clearplane as is usually customary when beginning DCC that the vector in the "Z" axis actually flips. So if you have a clearplane set for say an inch about the top surface of the part, it will actually slam down into the part instead of moving up? Has anyone had this issue and know what could be causing it and how to avoid it. It hasn't been as much an issue lately, but there was a few months not too long ago that everyday I came in and started up my part I would have to turn the jog box way down, cancel the execution, and then as if a blessing, when I re-executed the program, everything went back to the way it was? Very strange I know. Thanks guys!
Yeah I'm not sure. I appreciate you're comments. It hasn't happened in a few months, possible tied into PC-DMIS version before 2011 MR1 which we were running? I'm not sure if it had something to do with that, or something along the lines of the programs being stored on a shared server, possible cross communication. Whatever the reasoning I'm not sure we will ever find out. But if it does happen again, I will immediately save the code and post back on this thread. Thanks for the help!
Yeah I'm not sure. I appreciate you're comments. It hasn't happened in a few months, possible tied into PC-DMIS version before 2011 MR1 which we were running? I'm not sure if it had something to do with that, or something along the lines of the programs being stored on a shared server, possible cross communication. Whatever the reasoning I'm not sure we will ever find out. But if it does happen again, I will immediately save the code and post back on this thread. Thanks for the help!
