Does anyone know how to have PC-DMIS plot flatness result? We do this on other software and would like to do it on this software as well. It so we can see the contour, ie. dish, dome, potato chip. With this the machinists can determine the best route to bring the part into spec. Right now for example we have a part the is approximately 13" round and is dished on one side and domed on the other. All this is seen via the plot. All help is much appreciated.
- a normal flatness dimension
-
Insert ->
Report Command ->
Analysis..., select your flatness to the left, click
View Window... - You can now rotate the view just like the CAD window, set different
Options (like
Dimension options ->
Multiplier)
- When everything looks OK, choose
Options ->
Create Analysis View Command and close the windows.
- a normal flatness dimension
-
Insert ->
Report Command ->
Analysis..., select your flatness to the left, click
View Window... - You can now rotate the view just like the CAD window, set different
Options (like
Dimension options ->
Multiplier)
- When everything looks OK, choose
Options ->
Create Analysis View Command and close the windows.