Does anyone know how to have PC-DMIS plot flatness result? We do this on other software and would like to do it on this software as well. It so we can see the contour, ie. dish, dome, potato chip. With this the machinists can determine the best route to bring the part into spec. Right now for example we have a part the is approximately 13" round and is dished on one side and domed on the other. All this is seen via the plot. All help is much appreciated.
The instructions that Anders provided do work. The displayed result actually looks much better than the image you show, in my opinion. You must have missed a detail somewhere. Can you provide an image of what your display looks like after you follow the instructions that Anders provided?
The instructions that Anders provided do work. The displayed result actually looks much better than the image you show, in my opinion. You must have missed a detail somewhere. Can you provide an image of what your display looks like after you follow the instructions that Anders provided?
