Does anyone know how to have PC-DMIS plot flatness result? We do this on other software and would like to do it on this software as well. It so we can see the contour, ie. dish, dome, potato chip. With this the machinists can determine the best route to bring the part into spec. Right now for example we have a part the is approximately 13" round and is dished on one side and domed on the other. All this is seen via the plot. All help is much appreciated.
Ok so I have edited the code now and it looks much better. thank you for all your help. I increased the arrow density and set the multiplier to 10000. Yes twn thousand. But that works the best. Thanks again. Now I have to work on exporting data to excel, but thats next week. My day is finally over.
Ok so I have edited the code now and it looks much better. thank you for all your help. I increased the arrow density and set the multiplier to 10000. Yes twn thousand. But that works the best. Thanks again. Now I have to work on exporting data to excel, but thats next week. My day is finally over.
