Undimensioned Features

I'm looking for an option that appears in Zeiss' Calypso hoping that there's a similar approach with DMIS.
When programming a complex part with a model, I like to program around the part in a logical manner measuring all features
I can reach. I then dimension what I've measured to the customer's drawing. There are occasions where a feature on the part
is not dimensioned on the drawing but I've measured it. Calypso won't run a non dimensioned feature thereby leaving that feature grey as an indicator is wasn't dimensioned. This prevents me from missing anything on the part whether it's been dimensioned on the drawing on not. DMIS on the other hand will measure everything, dimensioned or not.
Is there a way for me to tell that one of say 500 features is measured but not dimensioned with DMIS?

Thanks

Parents

Paul Sarrach over 8 years ago

At the end or the beginning put a comment to report stating that.

And for those go to:

Edit/Preferences/Parameters/Dimension

Dimension output format? And unclick everything except

Nominal

Measured.

Remember to reformat for the next job or dimension. You can format before and after each dimension as needed. For example if you want to show Min/Max. If you are doing a set you can show all the points in a set for a Profile if you use the ANALISIS features in the Profile Dimension Window
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Reply

Paul Sarrach over 8 years ago

At the end or the beginning put a comment to report stating that.

And for those go to:

Edit/Preferences/Parameters/Dimension

Dimension output format? And unclick everything except

Nominal

Measured.

Remember to reformat for the next job or dimension. You can format before and after each dimension as needed. For example if you want to show Min/Max. If you are doing a set you can show all the points in a set for a Profile if you use the ANALISIS features in the Profile Dimension Window
Cancel
Vote Up 0 Vote Down

Sign in to reply

Cancel

Children

No Data