You'll need to create a parameter set for your probe. Load your probe, start typing autocalibrate and it tab. edit the code to select your parameter set and then you can calibrate your probe automatically, sort of.
You must keep in mind that if you have more probes, 1 must be the master probe to where you would say yes_man or yes_dcc to the parameter set. Once you can do this, you can get a little advanced and print the resutls and even have pcdmis repeat the autocal if std are not within acceptable limits.
You'll need to create a parameter set for your probe. Load your probe, start typing autocalibrate and it tab. edit the code to select your parameter set and then you can calibrate your probe automatically, sort of.
You must keep in mind that if you have more probes, 1 must be the master probe to where you would say yes_man or yes_dcc to the parameter set. Once you can do this, you can get a little advanced and print the resutls and even have pcdmis repeat the autocal if std are not within acceptable limits.
