Good morning everyone,
After searching the forum (seems using google to do it gets better results!), I can't find a
clear answer to this question that has been asked many times :
After calibrating A0B0, and additional angles - If I move the…
Hello everyone. I am having trouble trying to dimension to the midpoint of this radius callout, rather than the center. In the drawing, shown below, there is the .244 dimension from the centerline of the 45° BSC angle to the midpoint of the radius. I…
Hello! I am having trouble trying to dimension to an intersection point created by two constructed best fit lines. The dimensions (.150 and .250) are not measuring at nominal even though it is programmed off the CAD model. I made the constructed lines…
Hello all!
I have a cylindrical part mounted on a rotary table.
The print calls out 4 different angles on 4 subsequent sets of notches (each set of 4 having a different angle).
To measure the angles, I create an alignment, rotating the axis by the…
I have been trying to write a program for a part and have noticed that my part print nominals aren't matching up with my CAD nominal. After looking closely at the part print, I noticed a direction arrow and a die pull arrow with a degree called out. This…
