The command you need to use is CONCT2D (connect 2D elements). If you input your two axes (lines) as element 1 & element 2 with the diameter of your tangential circle as Value 2, you will get 4 potential results (since there are 4 possible contact locations for a circle tangential to 2 lines), so you need to enter 4 names in the result element(s) box (separated by commas). The Command should look something like this when all entries are complete
The command you need to use is CONCT2D (connect 2D elements). If you input your two axes (lines) as element 1 & element 2 with the diameter of your tangential circle as Value 2, you will get 4 potential results (since there are 4 possible contact locations for a circle tangential to 2 lines), so you need to enter 4 names in the result element(s) box (separated by commas). The Command should look something like this when all entries are complete
